15324980 12015359 Grey silicone wiring seal for waterproof connectors

2 The layout of the car engine wire beam

2.1 Precautions for Wiring Betting

In a limited engine space, reasonable wiring is extremely important. The chaos of the wiring is neither beautiful, but also unnecessary interference, affects performance, and is not convenient for later failure inspections and maintenance.

Therefore, the engine cable below needs to pay attention to the following points:

① The line beam should be along the edge, grooves and other parts of the engine to avoid the stress of the wire beam;

② When the line beam is wiring, it should be avoided in the cylinder or part of the component or the sharp edge part to prevent the wiring beam ripples from wear;

③ Try to avoid or stay away from the heat source when wiring. When wiring, you should avoid the fuel pipeline. When you cannot avoid it, you can use a high -temperature wire or heat insulation material;

④ Sensor or actuator connecting the connection to avoid vertical direction to prevent water and dust;

⑤ The fixing of the wire beam should be guaranteed by 150 mm bundling and fixed once;

⑥ The direction of the line beam should be consistent with the direction of the attachment.

2.2 Precautions for the layout of the line beam

1) The connector of all wire beams should be arranged in the position that can be extended, and the end of the connector should be reserved for a certain line beam length to facilitate insertion.

2) The wire beam of the fuse should be left with sufficient balance to facilitate the disassembly of the fuse box.

3) The connector in the same part can apply color, size, internal positioning and other methods to prevent mistakes.

4) In order to keep the gap between the wiring beam and the surrounding area, use a bracket or splint to ensure that the wire beam does not deform.

5) The cable beam above the engine, such as power cords, iron wires, etc. If it is too chaotic, you can develop a line bundle box box, concentrated in the box and wiring. At the same time The external water is caused by the short circuit.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.