24 pin 0-1379668-1 1379668-1 Automotive Electric Cable Harness Wire To Wire Connector 0.6 Series

1. Select a relatively stable position for the line beam. You cannot choose the location of the movement and the position with a large degree of disturbance.

2. Arrow the pressure connection near the interchange point of each signal line and the main trunk, which can effectively reduce the wires and save costs.

3. Selection of the contact position to avoid generating the back line, especially the wet area position, there is a backline, which is not conducive to Splice points seal.

4. The same pressure connection point, avoid more than 10 wires to co -pressure. In other words, once more than 10 wires are pressed, new pressure connection points need to be set up.

5. At the same pressure connection point, the wire diameter of the minimum wire diameter cannot be lower than the sum of the wire diameter of all the wires of all the voltage contacts.

6. Press the connection to the left and right sides of the line diameter is equal, and the smallest cannot be less than 50% on the other side

7. The wire diameter of the wire of the minimum line diameter of the pressure connection point is as greater than 16% of the maximum diameter of the pressure connection.

8. When one wire is connected to two pressure connection points, the distance between the two pressure connection points is not less than 150mm. The distance between SP1 and SP2 below is greater than 150mm.

9. The position of the pressure connection point and the branch point, the distance of the buckle/tie needs to be greater than 50mm, and the distance between the contacts is greater than 50mm (the exception of the CAN line), so as to effectively avoid contact between the contacts.

04 Protection of pressure connection point

If the protection of the wire beam contact is unreasonable, it will cause the wiring beam contact to pierce the insulation, or the connection to the water to form a short circuit failure.

Generally speaking, the distribution of automobile contacts is divided into two categories: dry and wet areas. The connection in the dry area is used for protection. Protection to achieve the effect of waterproof sealing.

As shown in the figure above, below the wading line is called a wet area, and the rest outside the dehumidifier area is a dry area.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.