4 pin 2-917807-2 Receptacle Housing Crimp 2 Row Cable Power Dynamic Wire To Board Connectors

The above test method is the pillar of the quality assurance of the current pressure technology. But please note that this does not mean that you can "choose something" from the list. Each test method itself is considered not enough! Only by combining these measures can we achieve consistent high -quality and repeated pressure connections.

In the fully automatic pressure -connected part, once the pressure connection or tool sets up and generates good pressure quality, there will be a variety of other detection systems that can be accompanied by production. In addition to sensor technology, these systems also use optical recognition to monitor the quality of each working step. The detected errors are classified directly by programming. This means that production will no longer be interrupted.

The possible control parameters of this monitoring system are:

● pressure relay monitoring

● The location of the sealing part (if there is)

● Insulation damage

● Lack of wire beam

● Insulation material card in the pressure connection area

● Line length

● The cutting depth of the thread -peeling knife

Modern measurement and testing methods can monitor and control many parameters in pressure connection technology.

However, because the cable processing involves the use of flexible parts (materials with unstable size), the technology is limited. Unlike the steel car cutting parts, the fine tuning wire cannot be fixed with too large tensile force. A soft line cannot bear it at all.

Although precise optical monitoring devices and measurement and testing methods have been mentioned, the experience of human eye and operator plays a very important role in high -quality pressure connection production.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.