Wanlian #:
Mfr. #: 1-917807-3
|
Wanlian part number: |
|
|
|
Original number: |
|
1-917807-3 |
|
Gender: |
|
Female |
|
Specification: |
|
Housing: PBT+G; PA66+GF; PA66; PBT; Nylon |
|
Type: |
|
Connector |
|
TUV, TS16949, ISO14001, ISO 9001, RoHS conform: |
|
Yes |
|
MOQ: |
|
No minimum order quantity |
|
Supply sample: |
|
Yes |
|
Customized drawing with Decal, Frosted, Print are available as request |
|
Yes |
|
Payment method: |
|
We accept Paypal, TT, Alipay, West Union etc. |
|
Transportation method: |
|
Air Transport: UPS, DHL, FEDEX etc; Sea Transport; Railway Transport; Freight Forwarding etc. |
|
Production Capacity: |
|
1000000pieces/Month |
Considering the cost of lightweight design and the laying of wire beam
On the basis of the easy assembly, maintenance and design reliability of the wire beam, special attention should be paid to the lightweight and wiring costs of the design of the wire beam design. There are the following aspects to consider:
1) Short the electrical circuit as much as possible
The electrical wire beam circuit must be shortened as much as possible. The circuit is short and the cost can be reduced, but also the cost reduction can be reduced. The short circuit can also reduce the power loss of the line segment.
For large wire diameters, the improvement of the circuit has been greatly improved, such as the battery positive cable.
2) Reduce line beam segments as much as possible.
In the actual thread beam design, to increase the line beam segment, the docking plug -in between the wiring beam must be increased, and the connection plug -in is bound to increase the weight and cost of the wiring beam. At the same time, it will increase the pressure drop on the line, which is not conducive to the stability of electrical performance.
Some German cars can see a line that runs through the engine compartment, the cabin, and the luggage compartment. This is a typical design of the small segment.
3) Don't design
Avoid using unnecessary line beam fixed points. Some areas of wire beam fixed points can achieve 300. At this time, 150 is not meaningful, increasing the weight and cost of the wire beam. It is also a waste for the assembly workshop.
4) Reduce the use of buckles of different specifications and reduce the use of new materials
Wire beam fixed parts, such as buckle, tie, rubber parts can be borrowed, and try to avoid the generation of new materials.
At the same time, minimize the types of tie/buckle as much as possible, and on the same wire bundle, avoid a 7mm round hole tie, and then it will be a lumbar hole tie of 7x12. These are not conducive to the wiring beam Generating processing.
Simple instructions：
We have product Catalogue，please contact us on skype，WhatsApp or Email.
If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.
