794758-1 Rubber Seal Automotive Waterproof Connector

3. The line color and diameter of the wire in the inner connector

When allocating circuit allocation, try not to distribute the same circuit with the same diameter of the wires into the same inner connector. Unless the terminal specifications of these two circuits are different, it is easy to cause the two circuit loads to reverse, and it will also bring fault maintenance. inconvenient. For circuits with the same line diameter and similar line color, such as orange and yellow, pink, and red, especially when these colors are used as auxiliary colors in the wires, it is easy to confuse, so try to avoid use in the same inner connector as much as possible. Essence For circuits with the same line color and similar line diameter, such as 0.35 and 0.5, 0.5 and 0.75, 0.75, and 0.85 wires, unless the color loop on the wire can be distinguished, it is easy to confuse and cause inconvenience to the wiring beam processing.

4. The circuit ranking in the internal connector

Try not to be too close to the circuit of large currents in the protective cover, otherwise it will easily cause local overheating. The same group of twisted lines should be located in the adjacent hole to avoid the unlocking distance, which leads to a decline in the effect of the antiphating and the distortion of the signal. Do not cross the bifema holes in different groups to avoid signal bunches. In order to maintain the continuity of the shielding layer, it is best to use an independent shielding cover when selecting the inner connector. It is not recommended to use ordinary sheaths, and do not allocate the shielding line and other wires into the same inner connector.

Assembly requirements

1. Color requirements of internal connectors

1) The colors of the public and parent -end protectives of the inner connector should be the same.

2) In order to maintain the coordination and unity of the color in the front cabin, the color of the inner connector located in the front cabin should be close to the color of the surrounding environment. Try to choose a deep color sheath such as black or gray.

3) For the facts of prevention, in the same area of the same model in the same area, different colors or branches that are not needed should be used to distinguish.

4) In the installation, the internal connector should be selected in the light in the light area.

5) Independent internal connectors used for airbag circuit should be selected.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.