8 pin 685080811 Cable Connector Automotive Terminal Wire Connector Plug

2.4.3 Direct examination

For the inspection of the wire, the resistance of the multimeter is required to measure the resistance of the wire. The specific operation method is as follows: First of all, the measured conductor is interrupted from the circuit, and then the multimeter is selected to select the appropriate range to contact the wire with the acupuncture of the multimeter. If the resistance exceeds the standard value, it is necessary to check whether the grounding and plugs of the wires are required.

2.4.4 Maintenance and installation of wires

(1) The maintenance of the wire When the wire is damaged, it is necessary to use the line diameter of the correct measuring damage to damage the wire according to the requirements of the line diagram.

The specific steps of connecting the disconnection line are as follows.

① Remove the negative electrode cable of the battery.

② Put a thermal tube on one end of the wire. The length of the thermal tube should be sufficient to seal the maintenance line segment.

③ Peel off the insulating layer of the wire end of the wire for 2cm.

④ Separate the core wire of the wire and twist the two wires together.

⑤ If needed, you can use electric iron to welded the maintenance line segment .

⑥ Move the thermal tube to the maintenance section and seal it.

After the wire maintenance is completed, it must be fixed to avoid damaging the insulating layer of the wire.

(2) When installing the car lines of the car beam, the precautions are as follows:

① The wire beam application card spring and trip nails are fixed to avoid loosening and grinding;

② The line beam should not be pulled too tightly at the corner or the parts where there is a relative movement;

③ When passing through the hole and bypassing the sharp corner, the protection of rubber, felt cushions or sleeves can be used to prevent it from being worn and cause the danger of iron, short circuit and even fire;

④ Each wiring terminal must be connected to reliable and good contact.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.