9 pin 144995-5 0-0144995-5 CWaterproof Auto Wire Harness Connector

3. How to judge the fault of the line beam line

Short -circuit of electronic system lines, electronic system felting, etc. are often faults in cars. The key to solving the fault when you find a specific short -circuit position. To check the circuit device of the overall electronic system, this work is relatively cumbersome, the workload is large, and it must be careful. Considering the security, the line beams of almost all models are arranged under the interior and close to the body. There are many buckle and tie bands installed on the entire line beam. The purpose is to avoid friction with other parts. In the fault check, these fixed points are generally removed. The wiring and fixing of the original car are more reasonable, but if the maintenance personnel have insufficient experience, it is difficult to restore the line layout of crude oil, it is easy to cause safety problems and cause life threats to the people.

After discovering the problem, we must take solve measures in a timely manner to prevent the problem from happening again. First of all, a comprehensive and accurate judgment of the place where the thread is possible. Under normal circumstances, the automotive electronic system supports more functions, and the system's wire beam is more complicated. A whole car line beam requires a lot of lines and related components. It is not easy to find a short -circuit point from such a huge and complex system. It is not easy to disassemble the instrument and interior, but also sometimes peel off the line beam for inspection.

4. Replacement of wire beam assembly

When we are driving, we often encounter the problem of turning off the car, and even continuously turn off the flames in a short time, and continue to repeat. For this situation, it is likely that the engine cable is aging. The main reason is that the temperature in most car engines is too high, and plastic heated out of some chemicals, such as plasticizers, and chemicals produced with copper cores will cause chemical reactions, resulting in a decrease in plastic strength and rising line resistance. Finally Causes the line to be aging. After the engine wire is aging, it is easy to wear through the friction, and it is easy to get in the body with the body. In addition, the temperature in the engine cabin is too high, which can easily lead to spontaneous combustion. Generally, there will be aging phenomena. In order to avoid this situation as much as possible, replace the aging wire beam in time. Usually, the wire beam on the engine is the fastest, but there are sheets outside, tape inside, there are tape inside, there are tape inside, there are tape inside, there are tape inside. Package, the extended place is short and the plug is short, so the short -circuit problem will basically not happen. In addition, the most dangerous is the headlight beam. It is easily corroded by electrolyte under the battery, and it is easy to rub the skin with the body friction with the body under the air filter.

Simple instructions：

We have product Catalogue，please contact us on skype，WhatsApp or Email.

If you can't find a product on our website or catalog, We deal with over 10,000 items, our catalog doesn’t cover all products. And we are developing 100+ molds yearly, which means around 10 new products are created in our factory. So don’t go away, just send us your photo or part no, we’ll check for you.